Replacement Vertical Blind Headrail, which is made to size.
Complete kit which includes all the fittings as well as either a wand or chain & Cord to operate.
Select from the listing the size group that matches your size.
Select the 'Draw Type' which will include whether you want a wand or cords.
In regards to the side of the controls; this is when you are looking at the blinds from the inside, and the blinds are fully closed.
Bare in mind... If the wand is on the right; it will stack to the opposite side as the wand is used to push the slats to the opposite end. Where if the cord is on the right, the blinds will stack to the right too, as the blinds will gather towards the cord.
Remember, these are only suitable for the 89mm slats.
Confirm the width size you are after in either a message or the notes during purchase, while also confirming whether the measurement that it is a recess size.
Also confirm the drop so we know what length we would need to make the cords etc to make sure it ties in with the 'Child Safety' laws.
Bare in mind, if you are providing the recess size, we will make slight adjustments, so it will fit.
PLEASE NOTE THAT OUR CARRIERS MAY VARY SLIGHTLY WITH SOME OF THE OLDER VERSIONS OF THE HEADRAILS, WHICH MAY EFFECT HOW MAY SLATS WOULD BE NEEDED.
Measuring
Recess size
This is where you measure wall to wall of the recess that the headrail will fit within. We would make a slight adjustment to allow the headrail (and side cog) sit within the recess.
Actual Size
This is normally when you are fitting the blind outside of the recess and you give us the actual dead size you need (including the headrail and side cog)
The Drop (Needed so we can make the cord the correct length)
You can measure either the recess size, the top to the sill or if not within a recess then from the top of the headrail to the bottom of the slat.
If you have any questions, please don't hesitate to contact us
